Strain Gage Module w/ Profibus Communication
Thru-Stroke Load Monitoring
- Two channel Strain Gage input with Auto Zero (350-700 ohm)
- PROFIBUS DP slave VO
- SSI encoder input
- DIN rail mount
- Peak or Through-Stroke models
- Pre-programmed screens for Siemens HMI’s
- Applications include Stamping, Forging, Die Cast, Injection Molding, Assembly and Weigh Scale
| Input impedance | 1K |
| Display resolution | up to .1% full scale |
| Overall accuracy | 1% full scale |
| Number of channels | 2 isolated |
| A/D | 12 bit |
| Normal mode rejection | 50db@2000 gain |
| Amp roll-off frequency | 650Hz@3000 gain |
| Calibration | software selectable |
| Indicators | alpha numeric display |
| Operating temperature | 0°-60° C |
| Machine position | SSI encoder |
| Module response time | 100µsec |
| Alarm output | 24vdc @ .25 amp |
| LAN controller | Siemens SPC3 |
| Data Rate | All PROFIBUS data rates up to 12Mbps |
Ordering Information ↑Top↑
| Application | Model |
| Peak Monitoring | HM-2-SSI-PLM |
| Through Stroke | HM-2-SSI-TSM |
When used with an encoder, the HM-2-SSI provides through stroke monitoring for stamping operations. High and low tracking alarms for each degree of crank angle provide optimum process control. The press curve as established by the press builder is digitized to become alarm set points in the HM-2-SSI module.
